Filter
Top Products
PROGRAMMING AUDIO CONTROL
Using the Millennium 4’s Audio mode, you can
also control an audio component, a stereo receiver,
or a stereo amplifier.
Locate the brand name of your audio component in
the one of accompanying code lists (starting on the
next page). Write it in the appropriate space.
Stereo Receiver Brand: ________________________
or
Stereo Amplifier Brand: _____________________
The brands are listed in alphabetical order with
popular codes listed first. You will use one of these
codes to program the Millennium 4 to operate
your audio component:
1. Turn on the audio component (or DBS
receiver to control its audio service).
2. On the Millennium 4, press AUDIO once.
Press and hold SETUP until the LED
blinks twice, then release SETUP.
3. Enter the first four-digit code for your
audio component. If you perform this
procedure correctly, the LED will blink
twice.
NOTE: If the LED did not blink twice after
entering the code’s last digit, then repeat steps 2
through 3 and try entering the same code again.
4.
Aim the Millennium 4 at your audio
component and press POWER once.
The unit should turn off. If it does not
respond, repeat steps 2-3, trying each
code listed for your brand until you find
one that works. If it still does not work ,
try searching for the code (see Searching
For Your Code on page 38).
5. Write your audio component code in the
boxes below for future reference.
NOTE: Remember, to use the Millennium 4 to operate
your audio component, press AUDIO first.
34