Filter
Top Products
ViewSonic N1700w 11
To adjust the screen image:
1. To display the OSD main menu, press button
of front bezel or the
MENU key of the remote controller. User can use the four arrow keys to
move the marker. Pressing MENU key when in the menu shall exit the
OSD menu.
NOTE: All OSD menus and adjustment screens Time-out automatically
after about 30 seconds.
2. The OSD is organized into “TABS” and “PAGES” pressing ← or → scrolls
through TABS. Pressing
↑
or
↓
navigates through the Pages.
3. After a page is selected, press button [Enter]. A control screen like the one
shown below appears.
4. To save the adjustments and exit the marker, press button [Enter].
The following tips may help you optimize your display:
Adjust your computer's graphic card so that it outputs a video signal 1280
x 768@ 60 Hz to the Display. (Look for instructions on “changing the
refresh rate” in your graphic card's user guide.)
If necessary, make small adjustments using H POSITION and V
POSITION until the screen image is completely visible. (The black border
around the edge of the screen should barely touch the illuminated “active
area” of the NexTVision
®
display.)
The ← left
A
rrow decreases,,
→
right arrow
increases
The other lines of
the screen tell you
what you can do
next: