Filter
Top Products
23
Remote Control Operation
1. Make sure that the component is turned on.
2. Press and hold the SETUP button on the Remote Control until the LED flashes twice.
3. Press992,then press the component button on the Remote Control twice.
Checking the Component Codes
If you have set up the Remote Control using the Searching for Component Code procedure, you may need to
find out which four-digit code is operating your equipment.
To find out which code is operating your TV :
1. Press the TV button once.
2. Press and hold the SETUP button until the LED blinks twice, then release the SETUP button.
3. Enter990.After this number sequence has been entered the LED will flash twice.
4. To view the code for the first digit, press 1 once. Wait 3 seconds, count the LED blinks (i.e., 3 blinks =3) and
write down the number.
5. Repeat step # 4 three more times for the remaining digits. Use 2 for the second digit. Use 3 for the third digit,
and 4 for the fourth digit.
6. To check the codes for your other components, repeat steps 1 through 5, but substitute the appropriate key (i.e.,
AUX, CBL, VCR, SAT, CD, AMP, or DVD) for the component you are checking. As before, write down each four-
digit code.
Changing Volume Lock
The Remote Control is set to control the volume through your TV while in cable (CBL), DVD, satellite (SAT) and
VCR component modes. Use the volume lock if you want to control the volume for all components through a
specific component.
Example:
You want to control volume for all components through your tuner.
1. Press and hold the SETUP button until the LED flashes twice.
2. Press993.After this number sequence has been entered the LED will flash twice.
3. Press the COMP button once that you want to control the volume (TNR). The LED flashes twice. Volume will
now be controlled through the tuner for all components.
Teaching the Remote Control New Functions
The remote control can learn up to 40 additional functions from the component's original remote control.
Note: If a code digit is "0", the LED will not blink.
Example:
Your DVD player remote control has a scan function that you may use frequently. There is not a scan button on the
remote control. you can assign a button and use the DVD remote to teach the remote control the scan function.
1. Press and hold the SETUP button on the Remote Control until the LED flashes twice.
2. Press975.After this number sequence has been entered the LED will flash twice.
3. Press the COMP button that you want to teach (DVD) once.
4. Press the button to which you want to assign the new function. The LED flashes quickly while it is waiting to
receive the signal from the teaching remote.
5. Hold the teaching remote control approximately 1-inch (25mm) from the Remote Control making sure that the
infrared ports are lined up, on the teaching remote press the button that you want the Remote Control to learn.
The LED flashes twice.
6. Press the SETUP button to exit the learning mode.