Filter
Top Products
WARNING:
The coolingfan in theREAR PROJECTION TVcontinues to runfor about 150seconds before theREAR
PROJECTION TVenters the standby mode.During normal Operation, whenputting the REARPROJECTION TV
into standbymode always usethe POWER buttonon the REARPROJECTION TV oron the remote control. Ensure
the coolingfan has stoppedbefore disconnecting thepower cord. DURINGNORMAL OPERATION, NEVER TURN
THE TELEVISION OFFBY DISCONNECTINGTHE POWER CORD. FAILURE TO OBSERVETHIS COULD RESULT IN
PREMATURE LAMP FAILURE.
WARNING :
EYEDAMAGE MAYRESULTFROM DIRECTLYVIEWINGTHE LIGHTPRODUCEDBYTHELAMP USED
INTHISAPPARATUS.ALWAYS TURNOFF LAMPBEFOREOPENINGTHIS COVER.
LAMP REPLACEMENT WARNING :
REFERTOTHE INSTRUCTIONMANUALBEFOREREMOVINGTHE SCREW,DISCONNECTPOWER
CORD.HOT SURFACE INSIDE.ALLOW45MINUTES TOCOOLBEFOREREPLACING THELAMP.
REPLACEWITH SAMELAMPUNITONLY.
THISCOVER ISPROVIDEDWITHAN INTERLOCKTOREDUCETHE RISKOFEXCESSIVE
ULTRAVIOLETRADIATION.DO NOTDEFEATITSPURPOSE ORATTEMPTTOSERVICEWITHOUT
REMOVINGCOVER COMPLETELY.
MEDIUMPRESSURE LAMP:RISK OFEXPLOSION. POTENTIALHAZARDOF GLASS PARTICLES IF
LAMPHAS RUPTURED.HANDLE WITHCARE.
iii
Potential hazardof glass particlesif lamp ruptures.
In caseof lamp rupture,contact your nearest
Authorized ProjectorDealer or ServiceCenter for a
replacement. See"Replacing the Lamp"on Page 31
Replacement LampPart Numbers:
UHP (120WLamp) RP51
USER SERVICE SCREW.
VIS POURENTRETIEN PAR
L'UTILISATEUR.
Caution Concerning Lamp Replacement
See "Replacing the Lamp" on Page 31,32
WARNING
EYE DAMAGEMAY RESULTFROM DIRECTLYVIEWING THELIGHT PRODUCED BYTHE LAMP
USED INTHIS APPARATUS.ALWAYS TURNOFF LAMPBEFORE OPENING THISCOVER.
WARNING
EYE DAMAGEMAY RESULTFROM DIRECTLYVIEWING THELIGHT PRODUCED BYTHE LAMP
USED
IN THISAPPARATUS.ALWAYSTURN OFFLAMP BEFORE OPENINGTHIS COVER.
LAMPREPLACEMENTWARNING
REFER TOTHE INSTRUCTIONMANUAL BEFORE REMOVINGTHE SCREW,DISCONNECT POWER CORD.HOT
SURFACEINSIDE. ALLOW 45MINUTES TOCOOL BEFORE REPLACINGTHE LAMP.REPLACEWITH SAME LAMP
UNIT ONLY.THIS COVER ISPROVIDED WITHAN INTERLOCK TOREDUCE THE RISKOF EXCESSIVE ULTRAVIOLET
RADIATION.DO NOT DEFEATITS PURPOSEOR ATTEMPTTO SERVICEWITHOUT REMOVING COVERCOMPLETELY.
MEDIUM PRESSURELAMP : RISKOF EXPLOSION. POTENTIALHAZARD OFGLASS PARTICLESIF LAMP HAS
RUPTURED. HANDLEWITH CARE.
LAMPREPLACEMENTWARNING
REFER TOTHE INSTRUCTIONMANUAL BEFORE REMOVINGTHE SCREW,DISCONNECT POWER CORD.HOT
SURFACE
INSIDE.ALLOW 45 MINUTESTO COOL BEFOREREPLACING THELAMP.REPLACE WITHSAME LAMP
UNIT ONLY.THIS
COVER ISPROVIDED WITHAN INTERLOCK TOREDUCE THE RISKOF EXCESSIVE ULTRAVIOLET
RADIATION.
DO NOTDEFEAT ITSPURPOSE ORATTEMPT TOSERVICE WITHOUT REMOVINGCOVER COMPLETELY.
MEDIUM
PRESSURE LAMP: RISK OFEXPLOSION. POTENTIALHAZARD OF GLASSPARTICLES IFLAMP HAS
RUPTURED.
HANDLE WITHCARE.