Woods Equipment MAN0063 TV Mount User Manual


 
10 Mount Installation
MAN0063 (12/15/00)
LOADER MOUNT INSTALLATION Cont’d
Attach Side Rails to Rear Mounts &
Front Support
1. Attach side rail to inside of right rear mount,
using four carriage bolts (12), flat washers (14), and
hex nuts (10) as shown in Figure 5.
2. Attach side rail to outside of front support, using
two cap screws (12), flat washers (14), and nuts
(10) as shown in Figure 6.
3. Repeat Step 1 and Step 2 to install left side rail
to left rear mount.
10. 230 5/8 Hex nut
12. 301130 5/8 1-1/2 Carriage bolt
14. 57817 5/8 Hardened flat washer
Torque Hardware
1. Torque all hardware to specifications given
below.
Figure 5 Side Rail Installed to Right Rear Mount
Figure 6 Side Rail Installed to Front Mount
12
14 10
12
14 10
TORQUE SPECIFICATIONS
Wrench
Bolt Qty Size Required Torque
3/4 NC x 1-3/4 HH cap screw 12 1-1/8” 297 lbs.-ft. (403 N-m)
3/4 NC x 2 HH cap screw 8 1-1/8” 297 lbs.-ft. (403 N-m)
5/8 x 1-1/2 Carriage bolt 12 15/16” 170 lbs.-ft. (230 N-m)
(Rev. 1/25/02)