16 Hydraulic Installation
MAN0063 (12/15/00)
#46675 Control Valve & #1001420 Hose Kit Cont’d
2
39
41
42
43
36
37
35
8
9
40
38
10
32
33
34
30
CD5740
11
Assemble Control Valve Kit
1. Install the control lever:
a.) Thread end of handle (1) into valve.
b.) Align handle so that end with longer bend is
pointing toward the adapter fittings. Make sure
bends are in line with front and rear of valve.
c.) Tighten jam nut (2) already installed on han-
dle.
d.) Slide boot down over boot bracket.
2. The valve mounting plate contains two sets of
holes. Select the holes that will position the valve in
the desired location. Install the valve mounting
plate (8) over the hose holder (10) and secure to
the right loader mount, using two 5/8 NC x 2 car-
riage bolts (40), 5/8 flat washers (41), lock washers
(42), and nuts (43) supplied in loader mounting kit.
NOTE: Carriage bolts must be installed so that the
head is inside the loader mount.
3. Attach the valve mount to the valve plate so that
the control valve will be in the correct position for
operation. Secure with three 1/2 NC x 1-1/2 car-
riage bolts (35), flat washers (36), lock washers
(37), and nuts (38) as shown.
4. Control valve must be positioned so that move-
ment of tractor controls is not restricted. Maintain at
least 6” spacing between control valve kit and any
tractor control (brake pedals, accelerator, hand
throttle, or hydraulic levers.) Check for clearances
in the operating position.
5. Torque all hardware
to specifications given below.
.
TORQUE SPECIFICATIONS
Wrench
Bolt Size Required Torque
5/8 NC x 2 15/16” 170 lbs.-ft.(230 N-m)
1/2 NC x 2 3/4” 85 lbs.-ft.(115 N-m)
Figure 13 2-Spool Control Valve Kit Assembly
8
.
46340 V
a
l
ve mount
i
ng p
l
ate
9. 56254 Bent handle
10. 44592 Hose holder
11. 53998 Right rear mount
30. 20973 3/8 x 1-1/4 Carriage bolt
32. 565 3/8 Flat washer
33. 838 3/8 Lock washer
34. 835 3/8 Hex nut
35. 29893 1/2 NC x 1-1/2
Carriage bolt
36. 3598 1/2 Flat washer
37. 855 1/2 Lock washer
38. 13859 Jam nut
39. 1093 1/2 Hex nut
40. 2855 5/8 NC x 2
Carriage bolt
41. 3632 5/8 Flat washer
42. 1286 5/8 Lock washer
43. 230 5/8 Hex nut
(Rev 1/25/02)