Filter
Top Products
Hydraulic Installation 11
MAN0063 (12/15/00)
CONTROL VALVE & HOSE KIT INSTALLATION
■ Keep hands and body away from pressur-
ized lines. Use paper or cardboard, not hands
or other body parts to check for leaks. Wear
safety goggles. Hydraulic fluid under pressure
can easily penetrate skin and will cause seri-
ous injury or death.
■ Make sure that all operating and service
personnel know that if hydraulic fluid pene-
trates skin, it must be surgically removed as
soon as possible by a doctor familiar with this
form of injury or gangrene, serious injury, or
death will result. CONTACT A PHYSICIAN
IMMEDIATELY IF FLUID ENTERS SKIN OR
EYES. DO NOT DELAY.
■ Air in hydraulic systems can cause erratic
operation and allow loads or equipment com-
ponents to drop unexpectedly. When connect-
ing equipment or hoses or performing any
hydraulic maintenance, purge any air in
hydraulic system by operating all hydraulic
functions several times. Do this before operat-
ing or allowing anyone to approach the equip-
ment.
■ Make sure all hydraulic hoses, fittings, and
valves are in good condition and not leaking
before starting power unit or using equipment.
Check and route hoses carefully to prevent
damage. Hoses must not be twisted, bent
sharply, kinked, frayed, pinched, or come into
contact with any moving parts. Operate move-
able components through full operational
range to check clearances. Replace any dam-
aged hoses immediately.
■ Protective hose sleeves must cover all
hydraulic hoses and be secured onto metal
hose fittings. Replace hoses or sleeves if dam-
aged or if protective sleeve cannot be properly
positioned or secured.
IMPORTANT
■ Hydraulic valves must be connected to the
tractor hydraulic system as shown in this
loader mounting kit manual.
■ If hydraulic lines are not connected as
shown in the mounting kit manual, the loader
control valve may be damaged. A blocked out-
let (Return) or improper hose connection will
cause pressurized oil to enter the return circuit
and damage the valve.
COMPLETION OF THIS INSTALLATION REQUIRES CONNECTION TO THE LOADER,
ASSEMBLED ACCORDING TO INSTRUCTIONS IN MANUAL #56060.
THE FOLLOWING INSTRUCTIONS ARE FOR OPERATING THE LOADER USING
THREE OPTIONS:
#57923 Hose Kit using tractor remote controls . . . . . . . . . . . . . Page 12
#46675 Control Valve Kit & #1001420 Hose Kit
(For use with 1020/1027 Loaders) . . . . . . . . . . . . . . . . . . . . . . . . Page 15
1
2