2. Testing Started
10
2.4. Register the Tool
The scan tool can be applied to diagnosis for only
15 times before the tool is required to be
registered on line. Testing for one same vehicle is
defined as one time only if the tool is not powered
off.
NOTE: No update can be carried out before
the tool is registered.
To register the scan tool, please follow these
steps:
1. Log on the website www.maxidas.com.
2. Click on the Update tool bar at the top of the
screen, and then select User Register. Or,
Click on the Updates column in the lower
right corner of the screen, and select Register.
3. The screen of Register Information appears.
Please read through the instructions, and click
on Agree to continue.
4. Put in the Product Serial No. and Register
Password, and click on “Next”.
NOTE: Please use the System/Help > About
function to find out the Product Serial No.
and Register Password. For details, please
refer to the Section 5.11 About on page 38.
Figure 2.7: Registration Information Screen
5. Follow the instructions on screen to finish the
registration.
2.5. Test Startup and Vehicle
Connection
Step 1: Connect the Cable.
Step 2: Enter the Vehicle information.
Step 3: Select the Diagnostic Function.
For details, please refer to Section 3.1 Test Startup
and Vehicle Connection on page 11.
