Filter
Top Products
Autolocation, Chapter 9
9-2 ALESIS M20 REFERENCE MANUAL 1.06
To select and edit location points:
Operation You press… You see…
Copy Tape Location to
memory
Copy Tape Location
button
Tape counter time
(display left side) is
copied to the Locate
Point indicator on the
display’s right side
(Reference Counter).
Store Locate Point Set Locate button Locate Point display
shows the current time;
the location block shows
the locate point number
Select Locate Point Locate Select button, then
Up/Down Arrows or
number keys to select the
desired location point
Locate Select display
shows the location point
number and name; the
locate point block shows
the locate point number;
Reference Counter (if in
Locate Pt mode) shows
the point time.
Edit Locate Point Locate Select button, then
press Cursor Left/Right
to select the field to be
edited (it will flash). Use
Up/Down Arrows, or
number keys to enter the
new value
Locate Point display
(Reference Counter)
shows the location point
time; the locate point
block shows the locate
point number
Edit Locate Name Locate Select button, then
Enter/Name button.
Enter the name.
Locate point block shows
the locate point number
Go to Locate Point After selecting the
desired Locate Point
(using Select Locate
mode), press Locate.
The Rewind or Fast
Forward button flashes
to indicate the direction
of the search. The Locate
button stays lit until the
tape reaches its
destination.
Locate to Zero* Locate 0 button The Rewind or Fast
Forward button flashes
to indicate the direction
of the search. Locate 0
lights stays lit until the
tape reaches its
destination.
*Whether the tape counter display is ABS (Absolute), Relative, or SMPTE, the zero point is
always at ABS 00:00:00:00 (the beginning of the audio section, just after the leader).