14-EN
+01GB05IVAD105.fm
ALPINE IVA-D105 68-08564Z59-A (EN)
Display example for FM Radio main screen
Displays the preset number/frequency.
This unit cannot receive HD Radio™ signals (digital
terrestrial radio). In order to activate the digital radio
functions described below, an optional HD Radio Tuner
module must be connected through the Ai-NET bus.
Listening to the Radio
1
Press SOURCE/ .
The SOURCE selection screen is displayed.
Receiving Analog Radio:
2
Touch [RADIO].
The radio mode is activated and the display changes to the
Radio Mode screen.
Receiving HD Radio (if TUA-T500HD is connected):
2
Touch [HD RADIO].
The digital radio mode is activated and the display changes
to the HD Radio Tuner Mode screen.
3
Touch [BAND] to select the desired radio band.
Each press changes the bands as follows:
4
Touch [TUNE] to choose the tuning mode.
Each touch changes the tuning mode display.
• There are two modes you can select for auto tuning, DX and
Local:
- DX (Distance) mode (with DX SEEK indicator ON);
Both strong and weak stations will be tuned in.
- Local mode (with SEEK indicator ON);
Only strong stations will be tuned in.
The initial setting is DX.
5
Touch [], [] or [], [] to change the
radio frequency up or down respectively.
In the manual mode, touch and hold to change the
frequency continuously.
• “DIGITAL” is displayed when a digital radio station is received.
• Also refer to “Digital SEEK Setting” (page 34).
Manual Storing of Station Presets
1
Tune in a desired radio station you wish to store in
the preset memory by manual or automatic seek
tuning.
2
Touch [PAGE1/2]* to change the function guide.
*“[PAGE 1/3]” is displayed in the HD Radio mode.
3
Touch and hold any one of the preset buttons [P-1]
through [P-6] for at least 2 seconds.
The selected station is stored.
4
Repeat the procedure to store up to 5 other stations
onto the same band.
To use this procedure for other bands, simply select the
band desired and repeat the procedure.
A total of 18 stations can be stored in the preset memory (6
stations for each band; FM1, FM2 and AM).
• If a preset memory has already been set in the same preset number, it
will be cleared and the new station will be memorized.
Automatic Memory of Station Presets
The tuner can automatically seek and store 6 strong stations in the
selected band in order of signal strength.
After selecting the desired band, touch [A.MEMO].
The tuner automatically seeks and stores 6 strong stations into
[P-1] to [P-6] in order of signal strength.
When the automatic storing has been completed, the tuner goes
to the station stored in [P-1].
• If no stations are stored, the tuner will return to the original station
you were listening to before the automatic storing procedure began.
Tuning to Preset Stations
You can tune in the preset stations in memory on each band using the
preset number.
1
After selecting the desired band, touch [PAGE1/2]*
to change the function guide.
*“[PAGE 1/3]” is displayed in the HD Radio mode.
2
Touch any one of the preset buttons [P-1] through
[P-6] that has a station stored to it.
The preset station is received.
Radio
FM-1 FM-2 AM FM-1
Distance Local Manual Distance
+01GB00IVAD105.book Page 14 Monday, January 15, 2007 4:02 AM