Filter
Top Products
28-EN
+01GB05IVAD105.fm
ALPINE IVA-D105 68-08564Z59-A (EN)
Internal MP3/WMA/AAC/DivX Player/external MP3-
compatible DVD Player/Changer Mode
1 The folder list screen appears.
Select a desired folder and then touch [].
([] appears only when a file is present in the selected
folder.)
The file list screen is displayed.
2 Touch [] of a desired file name.
The selected file will be played back.
Rear Selection Function
While listening to the radio or other audio source, at the same time,
pictures in a disc inserted in the IVA-D105 can be enjoyed in the rear
monitor. However, only pictures are output, not sound.
1
Press SOURCE/ .
The SOURCE selection screen is displayed.
2
Touch [REAR].
Rear Select display appears.
• This function cannot be used when “Setting the Picture/Sound
Output” (page 38) is set to OFF in the SYSTEM SETUP.
• If [MAIN] on the Rear Select screen is touched, the screen
changes to the main source screen.
3
Touch the desired source such as visual (auxiliary
input, built-in DVD, etc.) to select.
• Touch [OFF] to cancel the rear entertainment function.
• When the “Setting the AUX Mode” (page 37) is set to OFF, the
auxiliary source is not displayed.
Switching Display Modes
After carrying out the steps 1 to 3 of “To display the DVD mode
Screen” explained on page 29, perform the operation described below.
While your vehicle is parked, touch [WIDE] on the visual
source screen or press BAND on the unit.
Each touch changes the display modes as follows:
In Mode 1 (Wide), the monitor displays a normal picture wider to
fit in a wide-screen monitor by evenly stretching out the picture
horizontally.
In Mode 2 (Cinema), the monitor displays a normal picture by
stretching out the picture horizontally and vertically. This mode is
good for displaying a cinema type picture at the 16 : 9 ratio.
In Mode 3 (Normal), the monitor displays a normal picture at the
center of the screen with a vertical black band at each side.
Switching the Visual Source Only
(Simultaneous Function)
You can watch the video portion of another source while listening to the
current source.
• After carrying out the steps 1 to 3 of “To display the DVD mode
Screen” explained on page 29, perform the operation described
below.
1
Press VISUAL on the unit.
The VISUAL selection screen appears.
2
Touch a desired visual source.
The visual source is switched to the selected one.
1
Press VISUAL.
2
Touch [NORMAL].
The simultaneous function is canceled.
• To apply the setting, set to VISUAL in “Setting the VISUAL Button”
(page 38).
• If a DVD player is connected, you can receive the DVD picture.
DVD changer (DHA-S680) is connected:
Press and hold V.OUT on the remote control supplied with the DVD
player or DVD changer for more than 2 seconds. The picture of the
DVD will be output.
The DVA-5210 is connected:
Press V.OUT on the remote control (included with the DVA-5210) to
output DVD picture.
• The simultaneous function cannot be used when the Audio source is
in the navigation mode.
When NAV. is set in “Setting the VISUAL Button” (page 38), only the
navigation screen can be recalled.
• When the “Setting the AUX Mode” (page 37) is set to OFF, the
auxiliary source is not displayed.
• Touch [] to play back the folder directly.
MODE 1 MODE 2 MODE 3 MODE 1
(WIDE) (CINEMA) (NORMAL) (WIDE)
®
Cancelling the Simultaneous Function
+01GB00IVAD105.book Page 28 Monday, January 15, 2007 4:02 AM