Filter
Top Products
40
i
The Motion Detection must be enabled first, the alarm sending
mail will send out the mail when detect motion.
- Alarm Out Time
Set the amount of time (in second) to continue sending the alarm once
activated
(2) Sensor Setup
- Sensor Status
Customize the initial state of the attached sensor for every camera. Refer to
the table below to customize the sensor state.
Not installed: Indicates that there is no sensor connected
Normal open: Indicates that the initial state of the sensor is normal open.
Video recording initiate when there is a changes in the sensor
state
Normal close: Indicates that the initial state of the sensor is normal close.
Video recording initiate when there is a changes in the sensor
state
- Sensor Record Time
Set the amount of time (in second) to record after the sensor has been
triggered
(3) E-Mail Setup
- SMTP
Enter the SMTP server
- User ID & Password
Enter User ID and Password for e-mail server user identification
- From
Enter the sender e-mail address
- To
The recipient e-mail address and separate it with a semicolon
- Subject
Enter the message title
- Message
Type the message