Filter
Top Products
-11-
Helpdesk: 0845 600 4911
2.8 Basic Television Controls
Before using your television, please refer to Section 3 for information on first time use
and automatic tuning.
Note 1: The sequence of operation of the Remote Control keys is illustrated on the
left side of the page for each function described in this section.
Note 2: The operations detailed in this section are described using the buttons of the
Remote Control.
2.8.1 Temporary on/off (STAND-BY)
When you press the red STANDBY button located on your remote control while your
television is switched on, the sound and the picture will go off. In the stand-by mode,
the power indicator of your television will glow brighter. To switch your television back
on, either press any numeric button or P+/P- buttons.
Caution! If you are not going to use your television for a long time, unplug the
mains lead from the mains.
2.8.2 Digital TV, Analogue TV and AV Mode selection
Press the Source button on your remote control. AV menu will be displayed. Select
DTV(Digital TV), ATV (Analogue TV) or desired AV mode from the Source menu with
up/down movement buttons and confirm with OK button so that your television will
switch to the source you have selected.
2.8.3 Channel Selection
You may select program number you would like by pressing the P+/P- buttons on
your television and on your remote control. To select the programs that are above
9, you can use the Numerical buttons. You may enter the number of the program
you would like to select using the numerical buttons. For example, to switch to the
program number 12, press the numeric buttons 1 and 2 on your remote control. You
can perform the program selection also from the Program Table and Channel List
menus.
2.8.4 Temporary sound mute (MUTE)
To temporarily mute the sound of your television, press the MUTE button on your
remote control. The MUTE symbol will appear on the screen. When you press
the same button a second time, the sound will be restored. If you press the VOL+
button while in the Mute mode, the sound level is increased and the Mute function is
aborted.
2.8.5 Returning to the Last Viewed Program (SWAP)
Allows you to switch between the current program you are watching and the source,
or the last selected program and the source. For example, if you change the channel
to Program 11 while you were watching Program 1, press SWAP button to switch
back to Program 1. Press SWAP button to switch back to Program 11 again.