Filter
Top Products
23
Using the projector
English
Utilizing the password function
For security purposes and to help prevent unauthorized use, the projector includes an option for setting up
password security. The password can be set through the On-Screen Display (OSD) menu. Once the
password is set and this function is selected, the projector is password-protected. Users who do not know
the correct password can not use the projector.
You will be inconvenienced if you activate the password functionality and subsequently forget the
password. Print out this manual (if necessary) and write the password you used in this manual, and keep
the manual in a safe place for later recall.
Setting a password
Once a password has been set and activated, the projector cannot be used unless the correct password is
entered every time the projector is started.
1. Press MENU/EXIT and then press / until the Advanced Setup
menu is highlighted.
2. Press to highlight Password and press ENTER. The Password page is
displayed.
3. Highlight Password and press / to select On. The Input Password
page is displayed.
4. As the picture indicates, the four arrow keys ( , , , )
respectively represent 4 digits (1, 2, 3, 4). According to the password
you desire to set, press the arrow keys on the remote control or
projector to enter six digits for the password.
If the function is used for the first time, enter the default password (1,
1, 1, 1, 1, 1) of the projector by pressing the arrow key six times.
Once the password is set, the OSD menu returns to the Password page.
IMPORTANT: The digits being input will be displayed as asterisks on-
screen. Write your selected password down here in this manual in
advance or right after the password is entered so that it is available to
you should you ever forget it.
Password: __ __ __ __ __ __
5. To leave the OSD menu, press MENU/EXIT.
If you forget the password
If the password function is activated, you will be asked to enter the six-digit password every time you turn
on the projector. If you enter the wrong password, the password error message is displayed lasting for three
seconds, and the Input Password page follows. You can retry by entering another six-digit password, or if
you did not record the password in this manual, and you absolutely do not remember it, you can use the
password recall procedure. See "Entering the password recall procedure" on page 24 for details.
If you enter an incorrect password 5 times in succession, the projector will automatically shut down in a
short time.
Lamp Settings
HDMI Settings
High Altitude Mode
Password
Reset All Settings
Advanced Setup
EXIT Back
S-Video
ENTER
Off
Input Password
Password
Password
Change Password
On
EXIT Clear
EXIT Back
Expert Mode
Baud Rate
115200
Audio Settings
Lan Control Settings
Signal Power On Off
Direct Power On Off