BenQ SH960 Home Theater Screen User Manual


 
24
Using the projector
English
Entering the password recall procedure
1. Make sure the Input Password page is displayed on screen. Press
MODE. The projector will display a coded number on the screen.
2. Write down the number and turn off your projector.
3. Seek help from the local BenQ service center to decode the number.
You may be required to provide proof of purchase documentation to
verify that you are an authorized user of the projector.
Changing the password
1. Press MENU/EXIT and then press / until the Advanced Setup menu is highlighted.
2. Press / to highlight Password and press ENTER. The Password page is displayed.
3. Highlight Change Password and press ENTER. The Input Current Password page is displayed.
4. Enter the old password.
If the password is correct, the message "Input New Password" is displayed.
If the password is incorrect, the password error message is displayed lasting for three seconds, and
the message "Input Current Password" is displayed for your retry. You can press MENU/EXIT to
cancel the change or try another password.
5. Enter a new password.
IMPORTANT: The digits being input will be displayed as asterisks on-screen. Write your selected
password down here in this manual in advance or right after the password is entered so that it is
available to you should you ever forget it.
Password: __ __ __ __ __ __
Keep this manual in a safe place.
6. Confirm the new password by re-entering the new password.
7. You have successfully assigned a new password to the projector. Remember to enter the new password
next time the projector is started.
8. To leave the OSD menu, press MENU/EXIT.
Disabling the password function
To disable password protection, go back to the Advanced Setup >
Password > Password menu. Highlight Password and select Off by
pressing / . The message "Input Password" is displayed. Enter the
current password.
If the password is correct, the OSD menu returns to the Password
page with "Off" shown in the row of Password. You will not have
to enter the password next time when turning on the projector.
If the password is incorrect, the password error message is
displayed lasting for three seconds, and the message "Input
Password" is displayed for your retry. You can press MENU/EXIT
to cancel the change or try another password.
Note that though the password function is disabled, you need to keep the
old password in hand should you ever need to re-activate the password
function by entering the old password.
Please write down the recall code,
and contact your nearest BenQ
Customer Center.
Recall code:
0 2 1 2
Recall Password
EXIT Back
Password
Password
Change Password
Off
EXIT Back