Filter
Top Products
SYSTEM CONTROLS AND INDICATORS
31
&RQWUROV$QG,QGLFDWRUVIP
S
YSTEM CONTROLS AND INDICATORS
English FrançaisEspañol
4. Check that the LED turns off after the code is entered. If the LED blinks, the code is
invalid. Try again.
5.
Point the remote at your cable/satellite box and press the CBL-SAT On-Off button. If
your cable/satellite box does not respond, go back to step 2 and try other codes. If you
are still unsuccessful, see “Searching for a device code” below.
To set up the remote to control your VCR or PVR (such as Tivo or Replay TV)
1. Turn on both the 3•2•1 GSX system and your VCR or PVR.
2.
AUXAUX
Press and hold the AUX button until the remote LED is lit (about five seconds).
3. On the remote keypad, enter the four-digit device code for your VCR/PVR. The LED will
turn off temporarily as you press each key.
4. Check that the LED turns off after the code is entered. If the LED blinks, the code is
invalid. Try again.
5.
AUXAUX
Point the remote at your VCR or PVR and press the AUX On-Off button. If your VCR or
PVR does not respond, go back to step 2 and try other codes. If you are still unsuccess-
ful, see “Searching for a device code” below.
Searching for a device code
Use this method if you do not know the code for a device.
Note:
This is a very time-consuming process. Use it as a last resort.
To set up the remote to control your TV
1. Turn on both the 3•2•1 GSX system and your TV.
2.
Press and hold TV until the remote LED is lit (about five seconds).
3.
Alternately press Channel and TV On-Off until your TV turns off.
4.
Press Enter. Check that the remote LED turns off.
5.
Point the remote at your TV and press TV On-Off. If your TV does not respond, go back
to step 2 and try again.