Filter
Top Products
Standby / On*
The front Button turns the unit On
and put the player to Standby Mode.
Status LED will be GREEN when
player is powered ON.
Status LED
When the unit is turned off by the Remote Control
it will enter Standby Mode. This mode is indicated
by a glowing RED. The Status LED can indicate
when Paused, Reading Disc, Backward/Forward
Scan, Bad or Unrecognized Disc, enabled Setup
Menu and Playing Disc or ON.
Open / Close*
Push to Open or Close the disc tray.
Fast Forward / Next Track
Multi-Speed Fast Forward search during playback and Skips to the next chapter or Track
Fast Reverse / Previous Track
Multi-Speed Fast Reverse search during playback and Skips to the previous Chapter or Track
Stop
Press to stop play but hold resume location.
Press again to completely stop play and reset
playback to beginning of disc.
Play / Pause*
Press to begin Playback. Press again to Pause.
DVD Front Panel Functions
9
Quick Tips
When the unit is powered off by
the Remote Control, it will be in
standby mode. The Status LED
will be RED.
If the Remote Control is not
handy, you can bring the unit out
of Standby Mode by pressing the
Standby / On button on the front
bezel. The Status LED will be
GREEN.
If the Status LED is not RED or
Green, check the power switch
on the back or check your power
cord.
CH-DVD 300
Standby/On Turns ON Player and Plays Disc inside of Player
Play/Pause Turns ON Player and Plays Disc inside of Player
Open/Close Turns ON Player and Opens Disc Tray
*
When player is in STANDBY mode, you press the following buttons to power on the player: