Filter
Top Products
TroubleshootingInformationHDMI Control FunctionPlaybackSetupConnectionsGetting Started Specications
ENGLISH
Part Names and Functions
Rear Panel
For buttons not explained here, see the page indicated in parentheses ( ).
q
Q2 Q1 Q0 o i u
w e t yr
q 7.1ch AUDIO OUT connectors ··················· (16)
w VIDEO OUT connector ······························· (18)
e S-VIDEO OUT connector ···························· (18)
r COMPONENT VIDEO OUT connectors ····· (18)
t ROOM TO ROOM IN/OUT jacks
Extension jack for future use.
y RS-232C connector
Extension connector for future use.
u AC inlet (AC IN) ··········································· (20)
i ETHERNET connector ··························· (19, 20)
o HDMI OUT connectors ······························· (13)
Q0 DENON LINK 4th connector ······················ (17)
Q1 DIGITAL OUT OPTICAL/COAXIAL
connectors ··················································· (15)
Q2 2ch AUDIO OUT connectors ······················ (18)
For software recorded in multi-channel, analog
signals that have been down-mixed into 2
channels are output.
NOTE
Do not touch the inner pins of the connectors on the rear panel. Electrostatic discharge may cause
permanent damage to the unit.
Do not put your nger or foreign object in the fan opening. Doing so could cause injury or unit failure.
When outputting audio from a DTS-HD 7.1-channel source to HDMI or analog 7.1 channel audio, and to
2-channel analog audio, perform the following settings so that the audio is down mixed to the correct
2-channel analog audio output signal as intended by the producer of the source and DTS, Inc.
In “HDMI Setup”, set “Audio Setup” to “2ch” (
vpage 23).
In “Audio Setup”, set “7.1ch Audio Out” to “2 Channel” (vpage 25).
If “Audio Setup” in “HDMI Setup” and “7.1ch Audio Out” in “Audio Setup” are not set to “2ch” or “2
Channel” respectively, 2-channel analog audio is output using this unit’s own downmix.
In this case, the downmix may differ from that intended by the producer of the source and DTS, Inc.
•
•
•
•
•
Getting Started