Filter
Top Products
ENGLISH
TroubleshootingInformationHDMI Control FunctionPlaybackSetupConnections Specications
About Media
Cautions on Using Media
Inserting a Disc
Set the disc with the labeled side facing up.
Make sure the disc tray is fully open when inserting the disc.
Place the disc horizontally in the tray, aligned with the tray guide.
•
•
•
NOTE
Only load one disc at a time. Loading two or more discs can damage
the unit or scratch the discs.
Do not use cracked or warped discs or discs that have been repaired
with adhesive, etc.
Do not use discs on which the sticky part of cellophane tape or
labels is exposed or on which there are traces of where labels have
been removed. Such discs can get caught inside the player and
damage it.
Do not use discs with special shapes, as they could damage the
player.
Do not push the disc tray in by hand when the power is turned off.
Doing so could damage the set.
•
•
•
•
•
If a disc that cannot be played is loaded or the disc is loaded up-
sidedown, “NO DISC” is displayed on the player’s display.
Inserting an SD Memory Card
Insert an SD Memory Card in the
direction of the arrow into the SD
CARD slot with the label facing up.
Insert the card straight into SD CARD
slot until it clicks.
To remove the card, push it in the
direction of insertion, and then release
to eject.
•
•
•
About Handling of Media
Do not get ngerprints, oil or dirt on discs.
Take special care not to scratch discs when removing them from
their cases.
Do not bend or heat discs.
Do not enlarge the hole at the center.
Do not write on the labeled (printed) surface with ball-point pens,
pencils, etc., or stick new labels on discs.
Water droplets may form on discs if they are moved suddenly from
a cold place (outdoors for example) to a warm place, but do not try
to dry them off using a hairdryer, etc.
Do not eject an SD Memory Card or turn off the DBP-4010UDCI’s
power while the card content is in playback. This may result in
malfunction or loss of the card’s data.
Do not attempt to open or modify SD Memory Cards.
SD Memory Cards and les can be damaged by static electricity.
Do not touch the metal contacts of an SD Memory Card with your
ngers.
Do not use warped SD Memory Cards.
After use, be sure to remove any disc or SD Memory Card, and store
it in its proper card case, to avoid dust, scratches and deformation.
Do not store discs in the following places:
1.Places exposed to direct sunlight for long periods of time
2.Dusty or humid places
3.Places exposed to heat from heating appliances, etc.
•
•
•
•
•
•
•
•
•
•
•
•
Cleaning Discs
If there are ngerprints or dirt on discs, wipe them off before using
the disc.
Use a commercially available disc cleaning set or a soft cloth to
clean discs.
•
•
Gently wipe the disc from the
inside towards the outside.
Do not wipe with a circular
motion.
NOTE
Do not use record spray, antistatic agents, or benzene, thinner or
other solvents.
About Copyright
Unauthorised copying, broadcasting, public performance and
lending of discs are prohibited.
This product incorporates copyright protection technology that is
protected by U.S. patents and other intellectual property rights.
Use of this copyright protection technology must be authorized by
Macrovision, and is intended for home and other limited viewing
uses only unless otherwise authorized by Macrovision.
Reverse engineering or disassembly is prohibited.
Portions of this product are protected under copyright law and
provided under license by ARIS/SOLANA/4C.
•
•
•
•
Getting Started
SD
Memory Card
SD
Memory Card