Filter
Top Products
QSD42908 User’s Manual
62
5.14 Network Parameters
If you want to access the DVR over a network you must setup network parameters.
Note: If any network parameter is modified, you must save and reboot the DVR to make it
effective.
In main menu, move the “Active Frame” to the “Network” icon and press【ENTER】, you
will enter into “Network” menu as shown in fig 5.27
Fig 5.27 network setup
“Network” menu description:
IP address: This IP address must not be conflict with another IP address on the router. If
there is a DHCP server in the network, you can set the IP as “0.0.0.0”, save and reboot the DVR.
In reboot process, the DVR will search the DHCP server and get one dynamic IP address. This
item will display the dynamic IP address. If DVR uses PPPoE function the DVR can dial into the
internet and this item will display the dynamic internet IP address.
Port: Network access port number, must be greater than 2000.
Mask: This is sub net mask.
Gateway: The gateway IP is used to communicate with different network segments, it is the
network IP of the router the DVR is attached to.