Filter
Top Products
QSD42908 User’s Manual
67
5.17 PTZ (Pan, Tilt, Zoom)
There is one RS-485 port on the DVR rear panel used for PTZ camera control. You can setup
RS-485 parameters to match your PTZ protocol. In main menu, move the “Active Frame” to PTZ
icon and press【ENTER】key, you will enter into PTZ menu as shown in fig 5.29
Fig 5.29 PTZ parameters setup
PTZ menu description
Select channel: Select a PTZ camera.
RS-485 parameters: Including baud rate, data bit, stop bit, parity, flow control, etc. These
parameters must be the same as those of PTZ. Protocol.
PTZ address: Each PTZ has a different address.
PTZ type: DVR supports the following PTZ protocols: YouLi, LinLin-1016, LinLin-820,
Pelco-p, DM DynaColor, HD600, JC-4116, Pelco-d WX, Pelco-D, VCOM VC-2000, NetStreamer,
SAE/YAAN, Samsung, Kalatel-312, CELOTEX, TLPelco-p, TLHHX-2000, BBV, RM110,
KC3360S, ACES, ALSON, INV3609HD, Howell, Tc Pelco P, Tc Pelco D, AUTO-M, AUTO-H,
ANTEN, CHANGLIN, DeltaDome, XYM-12, ADR8060, EVI-D30, DEMO-SPEED,
DM-PELCO-D, ST832, LC-D2104, HUNTER, A01, TECHYIN, WEIHAN, LG, D-MAX,
Panasonic, KTD-348, infinova, PIH-7625, LCU, DennarDome, etc. Other PTZ protocols may be
added with new firmware updates.
Note: In DVR “PTZ” menu, if you select Pelco-P protocol, when you setup PTZ address,