Filter
Top Products
QSD42908 User’s Manual
86
3) Modify the bits per second to ‘115200’. and modify the flow control to “None”. Then click
“apply” and “ok” to enter into the hyper terminal main interface.
㱒
ᘉig㱒㱧㱒㱒
Step 2:
Then reboot the device and press any button in the pc keyboard again and again until the HIK
# comes out in the Hyper Terminal interface, shown as fig 6, then input “print” to check if the IP
of the server and device are correct, also both of them should be in the same LAN. You can use the
command:
“set serverip” to modified the server IP
“set ipaddr” to modified the device IP
“set netmask” to modified the mask IP
Shown as fig 7.