DirecTV D10-200 Satellite TV System User Manual


 
25
24
CHAPTER 2
Setting up and connecting
2
2
CHAPTER 2
Setting up and connecting
2
2
Connection option B:
DIRECTV Receiver to TV with A/V cables
If connection option B best matches your needs, follow these steps:
1
Make sure your TV and DIRECTV Receiver are turned off and unplugged.
2
Connect the RG-6 coaxial cable running from your satellite dish to the SATELLITE IN jack on the
back of your DIRECTV Receiver.
3
Connect the supplied phone cord to a telephone wall jack and to the Phone Line jack on the
back of the DIRECTV Receiver.
4
Matching like colors, connect the supplied A/V cable to the AUDIO OUT and VIDEO OUT
jacks on the back of the DIRECTV Receiver.
5
Connect the other ends of the A/V cables to the audio and video input jacks on your TV.
Be sure to connect the outputs on the DIRECTV Receiver to corresponding inputs on your TV
(video out to video in, left audio out to left audio in, right audio out to right audio in).
6
(Optional) if your TV has an S-Video input jack, connect one end of an S-Video cable to the
S-VIDEO jack on the back of the DIRECTV Receiver. Connect the other end of this cable to the
S-Video In jack on the back of your TV. This step is optional; it provides improved picture
quality on some TVs.
7
Plug in the power cords for your DIRECTV Receiver and TV.
To watch DIRECTV
®
programming
Set your TV to the appropriate input mode. This is a setting on your TV usually controlled
by a Video, Input, or Mode button. See the manual for your TV for instructions.
DIRECTV Receiver
TV
D10-200 CHAPTER 2-ENG_01 8/23/04 2:19 PM Page 24