Filter
Top Products
Remote Controls
73
Improving Receiver Control
Confirming Remote Control Operation
1. Make sure the remote has fresh batteries and is in SAT mode.
2. Press SYSTEM INFO on the receiver front panel to display the system information screen on
the nearby TV.
3. Press RECORD on the remote control:
• Remote Control 1 - The Primary Remote Address in the system information screen changes to
match the address preset in your remote control.
• Remote Control 2 - The Secondary Remote Address in the system information screen
changes to match the address preset in your remote control.
4. Press POWER on the remote controls to turn the receiver on or off.
Adjusting the Remote Control Antenna
Be sure to set the remote control antenna (back of the receiver) straight up so you can use the
remote control from as far away as possible. Don't let the antenna touch anything.
If your UHF Pro Remote Control 2 isn't working well from far away, you may be
experiencing interference from objects near your receiver. To improve your remote
control's range, try the following:
– Place the receiver higher than all of the other equipment in your
entertainment center.
– Provide room above the receiver so that the remote control antenna can
be installed straight up. If you cannot install the antenna straight up, tilt
the antenna at about a 30° angle.
– Place the remote control antenna outside the entertainment center by
using a coaxial cable to connect the antenna to the receiver.
– Try moving the receiver to other locations.
– Move any nearby over-the-air antennas away from the remote control
antenna. Do not place an over-the-air antenna on top of your receiver.
– Install a UHF attenuator. See Installing a UHF Attenuator for details.
1
2
3
4
Press
RECORD
If no operation,
press SYSTEM INFO on the
receiver to display the
System Information screen
SAT
Press
POWER
AAA
Battery
Check batteries
and press
SAT Mode
SYSTEM INFO