Filter
Top Products
20
Assembling the stand and removing the stand column
Adjusting advanced VGA settings
To change the advanced VGA settings:
1 Press MENU. The Picture menu opens.
2 Press or to select Setup, then press . The Setup menu
opens.
3 Press or to highlight Advanced, then press or ENTER.
The Advanced sub-menu opens.
4 Press or to highlight an option, then press or to adjust
the option. Available options include:
5 Press MENU to return to the previous menu or EXIT to resume
normal viewing.
Assembling the stand and
removing the stand column
You must install your TV into the stand in order for it to stand upright on
a cabinet or other flat surface. If you intend to mount your TV on a wall
or other vertical surface, you must remove the stand column.
Cautions:
Read these instructions thoroughly before attempting this installation.
Make sure that you handle your TV very carefully when attempting
assembly or removal of the stand. If you are not sure of your ability to
do this, or of your ability to use the tools necessary to complete this job,
refer to a professional installer or service personnel. The manufacturer
is not responsible for any damages or injuries that occur due to
mishandling or improper assembly.
When using a table or bench as an aid to assembly, make sure that you
put down a soft cushion or covering to prevent accidental scratching or
damage to your TV’s finish.
The speaker is not intended to support the weight of your TV. Do not move
or handle your TV by the speaker. This can cause damage to your TV
that is not covered by the manufacturer’s warranty.
Before attempting assembly or removal of the stand, unplug the AC power
cord.
To install the stand:
1 Remove the stand from the box and place it on a table or bench.
2 Hold your TV upright and align the stand column on the TV with
the stand groove on the stand, then insert the TV into the stand.
3 Gently push downward on the TV until it clicks into place.
Option Description
H-Pos Lets you adjust the horizontal position of the image to
the left or right.
V-Pos Lets you adjust the vertical position of the image up or
down.
Clock Lets you adjust the sample frequency of the image.
Phase Lets you adjust the phase of the image to improve the
focus.
Auto Lets you activate the auto adjustment setting, which
automatically optimizes the image.
Stand
Stand
Stand column
Stand groove
Push downwards