Filter
Top Products
Setting up your TV/DVD combo
9
Setting up your TV/DVD combo
Installing remote control batteries
To install remote control batteries:
1 Open the battery compartment cover.
2 Insert two AA batteries into the battery compartment. Make sure
that the + and – symbols on the batteries match the + and –
symbols in the battery compartment.
3 Close the cover.
Using the remote control
To use the remote control:
• Point the remote control at the remote control sensor on the front
of your TV. The remote control’s range is 30° to each side of the
remote sensor, 15° above and below the sensor, and within
26.25 ft. (8 m) of the sensor.
Caution: Do not expose the remote control to liquids, direct sunlight, or
shock. Do not mix batteries of different types.
Notes:
Objects between the remote control the remote control sensor may block
the remote control signal.
Direct sunlight or other bright light shining on the remote control sensor
may decrease the range of the remote control. In this case, change the
angle of the lighting, move your TV/DVD combo, or operate the remote
control closer to the remote control sensor.
Connecting an antenna or cable TV
(no box)
To connect an antenna or cable TV (no box):
1 Connect one end of a coaxial cable (not included) to the ANT IN
jack on the back of your TV/DVD combo, then connect the other
end of the cable into the antenna or cable TV wall outlet.
2 To improve picture quality from an antenna in a poor signal area,
install a signal amplifier.
3 If you need to split the antenna signal to connect two TVs, install
a two-way splitter.
Connecting a cable TV box with a coaxial
cable
To connect a cable TV box with a coaxial cable:
1 Make sure that your TV/DVD combo and the cable box are turned
off.
2 Connect a coaxial cable (not included) to the ANT IN jack on the
back of your TV/DVD combo, then connect the other end of the
cable to the coaxial out jack on the cable box.
3 Set the channel switch on the cable TV box to 3 or 4.
4 Turn on your TV/DVD combo and the cable TV box, then set the
TV channel to the same channel you selected in Step 3 (3 or 4).
5 Use the cable TV box controls or the cable TV box remote control
to change channels.
30° 30°
ANT
IN
ANT
I
N
Signal
Amplifier
ANTIN
Cable box