Filter
Top Products
26
MODEL TCL SECTION 7
PROGRAMMING THE ANALYZER
SECTION 7. PROGRAMMING THE ANALYZER
7.1 GENERAL
This section describes how to make the following program settings using the local keypad.
a. Configure and assign values to the analog current outputs.
b. Configure and assign values to the alarm relays (if the alarm board is installed).
c. Choose the type of chlorine measurement being made. This step is necessary because the analyzer used with
the TCL can measure forms of chlorine other than total chlorine.
d. Choose temperature units and automatic or manual temperature correction.
e. Set two levels of security codes.
f. Reset the analyzer to factory default settings.
7.2 DEFAULT SETTINGS
The analyzer leaves the factory with the default settings for total chlorine shown in Table 7.1. The setting can be
changed by the user to any value shown in the column labeled CHOICES. If you have a dual input 1056 analyzer,
refer to the 1056 instruction manual for information about the default settings for second input.