Filter
Top Products
99
Once you have a straight through cable plug one end into the LAN port on the back of
the recorder and the other into the router.
Now Log into the Everfocus DVR menu and using the jog dial from the previous chapter
go to the Network Setting Menu.
If you have a Linksys Router:
Assign an IP address of 192.168.001.050 to the DVR, a Subnet mask of
255.255.255.000, and a default gateway of 192.168.001.001.
If you have a D-Link Router:
Assign an IP address of 192.168.000.050 to the DVR, a Subnet mask of
255.255.255.000, and a default gateway of 192.168.000.001.
If you have a pre-existing LAN:
Go to a Computer on the pre-existing network and do the following:
o Go to Start, then Run and type cmd and click on OK.
Then hit enter, type ipconfig and press enter this will give you the information you
will need.
Use the prior step to assign an IP address. For example, if you got the IP address from
the computer of 192.168.002.101. Assign the DVR’s IP address as 192.168.002.050.
Now Copy the subnet mask and default gateway information you got from the prior
step off the computer to the DVR.