EverFocus EDSR 110 DVR User Manual


 
107
times, you would need to enable it. Web (HTTP) server is on LAN (Local Area Network)
computer 192.168.1.10 HTTP uses port 80, TCP and UDP.
Protocol Type - The protocol used for the virtual service.
Public Ports - The port number on the WAN (Wide Area Network) side that will be used to
access the virtual service.
Schedule - The schedule of time when the virtual service will be enabled.
The schedule may be set to Always, which will allow the particular service to always be
enabled. If it is set to Time, select the time frame for the service to be enabled. If the system
time is outside of the scheduled time, the service will be disabled.
The next step is to open ports within your router. Open virtual ports in the router.
o EDR Ports to open: 80, 1600, 1601, 1602, 1603, 37260, 37261, 37262, 37263
Note: If your Internet service provider blocks port 80 and you are using a
different port to access the DVR through the DVR’s Network Menu Setup
please open those specific ports in this section of the router.
Note: If you wish to have multiple users log into the DVR please open a range for
the control and data ports on your router. For example if you would only like 4
clients to connect to the DVR open 1600-1603 and 37260 ~ 37263
If your Internet Service Provider Blocks port 80. Simply do the following:
o Change the HTTP port from 80 to 8100 in the NETWORK MENU.
To access the DVR from a computer simply open Internet Explorer and in the address bar
type:
The following is the address you would type:
http:// (IP address of your internet service provider): 8100