Filter
Top Products
RCP 2000 with ISS 506 Support • Installation
Installation, cont’d
2-4
RCP 2000 with ISS 506 Support • Installation
2-5
Ethernet link
The RCP 2000 can also communicate
with the ISS 506 via an Ethernet link,
using the RJ-45 connectors on the RCP
and the ISS. The RJ-45 connector is
illustrated at right. The RCP 2000 can
be connected to the ISS either directly,
or indirectly through a LAN.
• When connecting the RCP 2000
directly (no intermediate device
present, such as a network hub)
to the ISS 506, you must use a
crossover cable. See the table
below for RJ-45 crossover cable connections (T568A and
T568B are the wiring standards).
Pin Wire color
RJ-45 Ethernet Crossover Cable
Pin
1
White-orange
White-orange
Transmit +
Transmit +3
2
Orange
Orange
Transmit –
Transmit –
6
3
White-green
White-green
Receive +
Receive +
1
6 Green
Green
Receive –
Receive –
N/A
N/A
4
Blue
Blue
5
White-blue White-blue
7 White-brown White-brown
8
Brown Brown
N/A N/A
N/A N/A
N/A N/A
Signal Signal
RCP 2000 end (T568B)
ISS 506 end (T568A)
Wire color
2
4
5
7
8
12345678
Insert
twisted
pair wires.
Pins:
Side View
• When connecting the RCP 2000 indirectly (through an
intermediate device, such as a network hub) to the ISS 506,
you must use a patch (straight-through) cable. See the
table below for RJ-45 patch cable connections (T568B is the
wiring standard).
Pin Wire color Pin
1
White-orange
White-orange
Transmit + Receive +1
2
Orange OrangeTransmit – Receive –
2
3
White-green White-green
Receive +Transmit +
3
4 Blue Blue
N/A N/A
N/A N/A
5
White-blue White-blue
6
Green Green
7
White-brown White-brown
8
Brown Brown
Receive –Transmit –
N/A N/A
N/A N/A
Signal Signal
RCP 2000 end (T568B)
Hub, etc., end (T568B)
Wire color
4
5
6
7
8
RJ-45 Ethernet Patch Cable