Filter
Top Products
RCP 2000 with ISS 506 Support • Operation
Operation, cont’d
3-14
RCP 2000 with ISS 506 Support • Operation
3-15
• In from the top and bottom edges to the center of the
screen — Soft Center In (#06) or Hard Center In (#18)
• Out from the center to the top and bottom edges of the
screen — Soft Center Out (#07) or Hard Center Out (#19)
Curtain In Curtain Out Center In Center Out
(#08 or #20) (#09 or #21) (#06 or #18) (#07 or #19)
Plus wipes
A plus wipe causes the preview image to appear to unroll over
the program image in one of the following ways:
• Starting in all four corners and moving in to the center of
the screen — Soft Plus In (#12) and Hard Plus In (#24)
• Starting at the center and moving out to the corners of
the screen — Soft Plus Out (#13) and Hard Plus Out (#25)
Plus In Plus Out
(#12 or #24) (#13 or #25)
Square wipes
A square wipe causes the preview image to appear to unroll
over the program image in one of the following ways):
• Starting at all four edges and moving in to the center of
the screen — Soft Square In (#10) and Hard Square In (#22)
• Starting at the center and moving out to the edges of the
screen — Soft Square Out (#11) and Hard Square Out (#23)
Square In Square Out
(#10 or #22) (#11 or #23)
Dissolve
Dissolve
Dissolve (PIP mode only)
A Dissolve sub-effect (#01 on the Sub-effects label)
is available for switching the PIP window only.
(To use a dissolve effect for a full-screen switch, see
“Dissolve mode,” earlier in this chapter.)
Setting a transition sub-effect
After you have selected wipe or PIP display mode, you can
select a wipe or PIP sub-effect that will be implemented when
the RCP switches from the preview to the program input. (The
Wipe button accesses the sub-effects in both wipe and PIP
modes.)
Selecting a wipe sub-effect
To select the effect with which the full screen transitions from
the preview to the program input,
1. Select wipe mode (see “Setting the Display Mode,” earlier
in this chapter).
2. Press and hold the Wipe button. The LCD
screen shows “Wipe,” along with the current
sub-effect number and duration.
3. While holding down the Wipe button, rotate the Adjust
knob until the number of the desired sub-effect is
displayed in the LCD window. (See the “Wipe and PIP
Sub-effects” label on the RCP’s top panel for a list of
available wipe effects and their numbers.)
4. Release the Wipe button and, while the button remains lit,
rotate the Adjust knob to set the amount of seconds that
the sub-effect will appear on the screen. You can set the
duration of the wipe sub-effect in increments of tenths of a
second, 0.0 to 0.5 seconds.
Selecting a PIP sub-effect
To select the effect with which the preview image in the PIP
window closes,
1. Select PIP mode (see “Setting the Display Mode,” earlier in
this chapter).
2. Press and hold the Wipe button. The LCD
screen shows “PIP,” along with the current
sub-effect number and duration.
3. While holding down the Wipe button, rotate the Adjust
knob until the number of the desired sub-effect is
displayed in the LCD window. (See the “Wipe and PIP
Sub-effects” label on the RCP’s top panel for a list of
available wipe effects and their numbers.)
Wipe #03
0.5 Sec
Pip #03
0.5 Sec