Filter
Top Products
RCP 2000 with ISS 506 Support • Operation
Operation, cont’d
3-18
RCP 2000 with ISS 506 Support
4
Chapter 4
Ethernet Control
Establishing a Connection
Logging On and Viewing System Status
Using the Configuration Screens
Managing Files
3. Rotate the H and V Adjust knobs to move the window
or the image up and down (V knob) or left and right
(H knob).
The Center button stays lit steadily while you are centering
the PIP window and blinks while you are centering the
image.
Adjusting the detail (sharpness)
To apply a lter to improve the sharpness of an image,
1. Press and release the Detail button. The button lights.
2. While the Detail button is lit, rotate either the H or V
Adjust knob to the right to increase the sharpness or to
the left to decrease it.
Resetting
There are three reset modes available by pressing the recessed
Reset button (
e
on page 2-3) on the rear panel, using a pointed
stylus, ballpoint pen, or Extron Tweeker.
C
Review the reset modes carefully. Using the wrong
reset mode may result in unintended loss of flash
memory programming, reassignment of ports, or
unit reboot.
Mode 1 — Stops all events. Press and hold
the Reset button until the LCD screen
shows “Reset Mode 1” (3 seconds), then
immediately press the button momentarily (for less than 1
second). The LCD screen displays “Unit reset” when the
Mode 1 reset is complete.
Mode 2 — Erases all user ash memory, resets
ports to default conditions, and reboots the
unit. Press and hold the Reset button until
the LCD screen displays “Reset Mode 2” (5 seconds), then
immediately press the button momentarily (for less than 1
second). The LCD screen displays “Unit reset” when the
Mode 2 reset is complete.
Mode 3 — Causes an absolute system reset to
factory defaults. Press and hold the Reset
button until the LCD screen shows “Reset
Mode 3” (10 seconds), then immediately press the button
momentarily (for less than 1 second). The LCD screen
displays “Unit reset” when the Mode 3 reset is complete.
N
Nothing happens if the momentary press does not occur
within 1 second.
Reset
Mode 1
Reset
Mode 3
Reset
Mode 3