Filter
Top Products
41
Appendix A - Advanced Connections
1 CONNECT CABLE TO
CABLE BOX
Connect an RF coaxial cable from
your cable wall outlet to the Input
jack on the Cable Box.
2 CONNECT CABLE BOX TO
DVD+VCR
Connect a second RF coaxial cable
from the Output jack on the Cable
Box to the “IN (FROM ANT.)” jack
on the back panel of the DVD+VCR.
3 CONNECT DVD+VCR TO TV
Connect the supplied RF coaxial
cable from the “OUT (TO TV)” jack
on the back panel of the DVD+VCR
to your television’s “Antenna In”
jack.
4 PLUG IN DVD+VCR
Connect the DVD+VCR power cord
to a standard 120V/60Hz wall outlet.
5 TURN ON DVD+VCR, TV &
CABLE BOX
Press POWER on the DVD+VCR, TV,
and Cable Box.
Follow these instructions to connect a Cable
Box to your DVD+VCR.
Input
Output
Cable Box
VHF/UHF
TV
From Cable
Wall Outlet
CABLE BOX HOOKUP
6 SET DVD+VCR OUTPUT
CHANNEL
Set the CH (channel) switch on the
back panel of the DVD+VCR to 3 or
4, whichever is NOT used by your
cable box.
7 TUNE TV TO THE SAME
CHANNEL
Tune your TV to the same channel
you selected in step 6.
8 CONNECTION IS COMPLETE!
The “Language/Langue/Idioma”
menu will appear on your television
screen. Please proceed with Auto
Setup on page 3.
• Use your cable box to select
channels.
• If you are not getting a good
picture, repeat steps 6 and 7
using the other channel; i.e., try
channel 4 instead of channel 3.