Insignia NS-1DRVCR DVD Recorder User Manual


 
30
www.insignia-products.com
Maintaining
Care and handling of discs
Handling discs
Do not touch the playback side of the disc. Hold
the disc by the edges so that fingerprints do not
get on the surface. Never stick paper or tape on
the disc.
Storing discs
After playing, store the disc in its case. Do not
expose the disc to direct sunlight or sources of
heat and never leave it in a parked car exposed
to direct sunlight.
Cleaning discs
Fingerprints and dust on the disc can cause
poor picture quality and sound distortion. Before
playing, clean the disc with a clean cloth. Wipe
the disc from the center out.
Do not use strong solvents such as alcohol,
benzine, thinner, commercially available
cleaners, or anti-static spray intended for older
vinyl records.
Resetting the recorder
Reset your recorder if you observe any of the
following symptoms:
When the recorder is plugged in, but the
power will not turn on or off.
When the display window does not working.
When the recorder does not operate
normally.
To reset the recorder:
Press and hold the POWER button for more
than five seconds. This forces the recorder to
turn off. Press the POWER button again to
turn the recorder back on.
- OR -
Unplug the power cord and then plug the
power cord again after more than five
seconds.
Specifications
General
Power requirements AC 120V, 60 Hz
Power consumption 24W
Dimensions (approx.) 16.9 × 3.1 × 10.2 in.
(w × h × d) (430 × 78.5 ×
266 mm)
Mass (approx.) 10.14 lbs (4.6 kg)
Operating temperature 41°F to 95°F
(5°C to 35°C)
Operating humidity 5% to 90%
Signal system NTSC
Cannot play
disc a
recorded on
your
recorder on
another
DVD player.
The disc was
recorded in Video
mode
Finalize the disc. See “Disc
Settings” on page 15.
Some players will
not play even a
finalized disc
recorded in Video
mode
No solution
The disc was
recorded in VR
mode
The other player must be RW
compatible in order to play the
disc
Discs recorded with
copy-once material
cannot be played on
other players
No solution
Cannot
record or
did not
record
successfully
The remaining blank
space on the disc is
insufficient
Use another disc
The source you are
trying to record is
copy-protected
You cannot record the source
When recording to a
Video mode disc,
programs that are
copy-once
protected cannot be
recorded
Use a VR mode formatted disc
for copy-once material
Stereo
Audio
Record or
Playback is
not present
Recorder A/V Out
jacks are not
connected to TV
A/V In jacks
Make A/V connections. Stereo
is available only on A/V output
from recorder.
Recorder
Audio/Video Out is
not selected for
viewing at the TV
Select AUX or A/V source as
TV input
Note
Never operate this product immediately after
moving it from a cold location to a warm
location. Leave it for two or three hours
without operating it. If you use this product in
such a situation, it may damage tapes, discs,
or internal parts.