Filter
Top Products
24
NS-51P680A12/NS-59P680A12
www.insigniaproducts.com
Selecting a channel
To select a channel:
• Press CH or CH to go to the next higher or
lower channel in the channel list.
• Press the number buttons to directly select a
channel. For example, if you want to view
channel 27, press 2, then press 7. Your TV goes
to the channel in a few seconds. If you want to
go to the channel quicker, enter the channel
number, then press ENTER.
• Press RECALL to go to the last viewed
channel.
• Press the number buttons for a main DTV
channel, press —, then press the number for a
DTV sub-channel to go to a digital
sub-channel (if available). For example, to go
to sub-channel 1 of main channel 7, press 7,
—, then 1.
Adjusting the volume
To adjust the volume:
• Press VOL – or VOL + to decrease or increase
the volume.
• Press MUTE to turn off the sound. Press
MUTE again (or press VOL– or VOL+) to
turn the sound back on.
Displaying additional information
To display additional information:
1 Press DISPLAY. Your TV displays status
information, such as the channel number, type
of sound, and picture and sound settings.
2 To close the display, press DISPLAY again or
wait about 10 seconds.
Adjusting the picture
Adjusting the TV picture
To adjust the picture:
1 Press MENU. The on-screen menu opens with
Picture highlighted.
2 Press ENTER to access the Picture menu.
3 Press
S or T to highlight an option, then press
ENTER to access the option.
You can select:
• Mode—Selects the picture mode. You can
select:
• Dynamic—Selects a high-definition
picture for bright environments.
• Standard—Selects the optimal picture
display for normal environments. This
setting is convenient for most situations.
• Movie—Selects a comfortable picture
display for dark environments.
• Contrast—Adjusts the contrast.
• Brightness—Adjusts the brightness.
• Sharpness—Adjusts the sharpness.
• Color—Adjusts the color saturation.
• Tint (G/R)—Adjusts the intensity of red in the
picture.
• Picture Options—Press ENTER to open a list
of advanced picture options. For more
information, see “Adjusting advanced picture
settings” on page 25.
• Picture Reset—Resets all picture settings to
the default settings. Press ENTER to reset
picture settings.
Notes
You can press the number buttons to go to a channel
that was skipped in the channel scanning.
TV #1
Fri, Dec 19 2:05 am
M. Spillane’s Mike Hammer
Bonocrunch
DTV Cable
13-1
Dolby Digital
480i 4:3 USA
Note
Unless otherwise noted, all tasks in this section are
based on using the remote control.
Note
You may need to pressT to see all the options.
Note
You can also press PICTURE one or more
times to select the picture mode.
Mode : Standard
Contrast : 95
Brightness : 45
Sharpness : 50
Color : 50
Tint (G/R) : G50/R50
Picture
Sound
Channel
Setup
Input