Filter
Top Products
19
NS-L42Q120-10A/NS-L46Q120-10A 42"/46" LCD TV
www.insigniaproducts.com
Turning your TV on for the
first time
The first time you turn on your TV, the Setup Wizard
opens. The Setup Wizard guides you through
setting up basic settings including the menu
language, TV signal source, and the channel list.
To set up your TV:
1 Make sure that you have:
• Installed the remote control batteries. (See
page 8 for details).
• Connected an antenna, cable TV, or satellite
TV. (See page 13 through page 14 for details.)
• Connected the power cord. (See page 13 for
details.)
2 Press (power) to turn on your TV. It may take
several seconds for the Choose your menu
language screen to open.
3 Press or to highlight a language, then press
ENTER. The Choose your TV source screen opens.
4 Press or to highlight the TV signal source,
then press ENTER to start scanning for channels
in that signal. You can select:
• Antenna—VHF and UHF channels
• Cable—Cable TV channels (no cable box).
• Cable/Satellite Box—Cable or satellite TV
tuner box. Channel auto scan is not necessary
if you select this option.
The channel scan may take a few minutes
depending on the signal strength and the
number of available channels. When the scan is
complete, the first scanned channel is displayed.
Understanding the basics
Turning your TV on or off
To turn you TV on or off:
1 Make sure that the power cord is connected to
your TV and to a power outlet.
2 Press (power) to turn on your TV. It may take
several seconds for an image to appear on the
screen.
3 Press (power) to turn off your TV. Your TV
enters standby mode.
Selecting the video input source
To select the video input source:
1 With your TV turned on, press INPUT. The Source
List opens.
2 Press or to highlight the video input
source, then press ENTER.
You can also press a direct input button to select
the video input source.
• Press TV to select TV.
• Press VIDEO once to select A/V 1(for VIDEO
IN 1 VIDEO or VIDEO IN 1 S-VIDEO).
• Press VIDEO twice to select VIDEO IN 2
VIDEO or VIDEO IN 2 S-VIDEO.
• Press COMP once to select Component 1.
• Press COMP twice to select Component 2.
Note
Unless otherwise noted, all tasks in this section are
based on using the remote control.
Warning
When your TV is off, power still flows into it. To
disconnect power, unplug the power cord.
Note
If your TV does not detect an input signal for several
minutes, your TV goes into standby mode
automatically.