Filter
Top Products
46
• Is “PC Card Viewer” selected from the Source menu?
• Is the CompactFlash memory card seated in the PC CARD slot completely?
• Are slide data stored in the CompactFlash memory card?
• Have the contents of the CompactFlash memory card been destroyed?
• While an image with over 1024ן768 dots is projected, several lines of information will be lost.
• Use a computer, etc., to repair the data.
Problem Check These Items
When using the PC Card Viewer function
For more information contact your dealer.
No picture
Part of a slide is not displayed
Contents of CompactFlash Card
are damaged
Common Problems & Solutions
Does not turn on
No picture
Image isn’t square to the screen
Picture is blurred
Image is scrolling vertically, hori-
zontally or both
Remote control does not work
Status indicator is lit or blinking
Cross color in RGB mode
• Check that the power cable is plugged in and that the power button on the projector cabinet or the
remote control is on.
• Ensure that the lamp cover is installed correctly. See page 44.
• Check to see if the projector has overheated or the lamp usage exceeds 1100 hours (up to 1600 hours
: Normal mode). If there is insufficient ventilation around the projector or if the room where you’re
presenting is particularly warm, move the projector to a cooler location.
• Use the menu to select your source (Video, S-Video, RGB or PC Card Viewer). See page 31.
• Ensure your cables are connected properly.
• Use menus to adjust the brightness and contrast. See page 31.
• Remove the lens cap.
• Reset the settings or adjustments to factory preset levels using the Factory Default in the Adjustment
Menu. See page 33.
• Reposition the projector to improve its angle to the screen. See page 23.
• Use the Keystone in the Adjustment Menu to correct the trapezoid distortion. See page 32.
• Adjust the focus. See page 23.
• Reposition the projector to improve its angle to the screen. See page 23.
• Ensure that the distance between the projector and screen is within the adjustment range of the lens.
See page 14.
• Use menus or Source button on the remote control or the cabinet to select the source you want to input.
• Install new batteries. See page 13.
• Make sure there are no obstacles between you and the projector.
• Stand within 22 feet (7 m) of the projector. See page 13.
• See the Status Light messages above.
• If Auto Adjust is off, turn it on. If Auto Adjust is on, turn it off and balance the image with the Position/
Clock in the Image Options. See page 33 or 36.
Problem Check These Items