Filter
Top Products
15
If Auto Set Up has been performed successfully:
1
Turn on the TV and select its AV mode, then make sure that all necessary stations have been stored in the recorder's memory
by using the CHAINE button(s).
● If station names (ID — ੬ pg. 21) have also been stored in the recorder's memory, the station name will be displayed at the
top left corner of the screen for about 5 seconds when the channel is changed.
● If you want to set the tuner manually such as to add or skip channels, to change preset positions, or to set or change station
names, see pages 18 – 21.
2 Perform "SHOWVIEW Setup" on page 24 to check if the Guide Channels have been set correctly.
If auto channel set has succeeded but auto clock set has not:
1
Turn on the TV and select its AV mode, then make sure that all necessary stations have been stored in the recorder's memory
by using the CHAINE button(s).
● If station names (ID — ੬ pg. 21) have also been stored in the recorder's memory, the station name will be displayed at the
top left corner of the screen for about 5 seconds when the channel is changed.
● If you want to set the tuner manually such as to add or skip channels, to change preset positions, or to set or change station
names, see pages 18 – 21.
2 Perform "Clock Set" on page 22, then "SHOWVIEW Setup" on page 24 to check if the Guide Channels have been set correctly.
If both auto channel set and auto clock set have failed:
1 Make sure the TV aerial cable is connected properly to the recorder and turn off the recorder power once, then turn the
recorder power back on again.
● The recorder will try Auto Set Up again.