Filter
Top Products
25
ENTER SHOWVIEW NUMBER
4
Press OK, and a cursor
appears above “NUMERO
GUIDE”. Then, using the
NUMBER keys, input the
SHOWVIEW number (found
in most TV listings) of a
program scheduled to be
broadcast on each station
on the list from step 1,
starting at the top. If you
enter the wrong number,
press ANNUL. to backspace
and input the correct number.
CONFIRM PRESET POSITION
NUMBER
4
5
Press OK and the display
under “CHAINE” begins
blinking.
If the blinking number
under “CHAINE” agrees
with the preset position . . .
. . . press OK.
If the numbers do not
agree . . .
. . . input the correct preset position using MULTI-
FONCTIONS %
fi
or the NUMBER keys, then press OK.
● If you input the SHOWVIEW number of a program that
has already aired, “ERREUR” appears on screen for a
few seconds. Input the correct SHOWVIEW number.
● Repeat steps 4 and 5 as necessary.
CLOSE MENU
6
Press MENU and selection is complete.
If you already know the Guide Channel for a station . . .
1– After step 3, press MULTI-FONCTIONS .
● The NUMERO GUIDE number begins blinking.
2– Enter the Guide Channel using the NUMBER keys or MULTI-
FONCTIONS
%
fi, then press MULTI-FONCTIONS .
● The CHAINE number begins blinking.
3– Enter the preset position using the NUMBER keys or MULTI-
FONCTIONS
%
fi, then press MULTI-FONCTIONS .
● Repeat 2 and 3 as necessary.
4– Press PROG./MENU.
When Using A Satellite
Receiver
Preparation
1– Connect the satellite receiver to the AV2 ENTREE/
DECODEUR connector on the rear of your recorder.
2– Set "SELECTION AV2" to "AUX" (੬ pg. 49).
To Record Satellite Broadcasts . . .
1– Select the appropriate channel on the satellite receiver.
2– Press NUMBER key "0" and/or CHAINE +/– to set your
recorder's input mode to "AUX2".
3– Start recording (
੬ pg. 35, steps 3 – 6).
To Record Satellite Broadcasts Using S
HOWVIEW Timer
Recording . . .
1– Perform Guide Channel setting.
● In step 5 in the left column, press NUMBER key "0" and/or
CHAINE +/– to set "CHAINE" to "AUX2".
2– Perform SHOWVIEW Timer Recording (੬ pg. 42).
To Record Satellite Broadcasts Using Regular Timer Recording . . .
1– In step 6 on page 45, press CHAINE +/– to set the channel
position to "AUX2".
NOTES:
●
When timer-recording a satellite programme, first set the
satellite receiver to the appropriate channel before the
selected programme begins and then set the satellite
receiver's timer. If your satellite receiver does not have a
timer, leave it switched on.
●
(*) In some areas, cable network is provided through a cable
box connected to the recorder via the 21-pin connector. In
this case, perform the same procedure as for a satellite
receiver.
AV2 IN/DECODER
Aerial or Cable (*)Satellite Antenna
Satellite
Receiver
TV Receiver
When entering a S
HOW
V
IEW
number for FR2
123455
NUMERO GUIDE CHAINE
REGL. DES NUMEROS
GUIDE 11
[0–9] =
[MENU] : SORTIE
NUMERO GUIDE CHAINE
2 2
[5∞] =
[MENU] : SORTIE
%
%
%