JVC HR-J449MS VCR User Manual


 
37
NOTES:
The B.E.S.T. system works for both VN and LD modes only
after a tape has been inserted and the Record mode is first
initiated. It does not work during recording.
In the case of timer recording, the B.E.S.T. system works
before recording is initiated.
Once the cassette is ejected, the B.E.S.T. data is cancelled.
The next time the cassette is used for recording, B.E.S.T. is re-
performed.
ATTENTION:
Since the B.E.S.T. system works before recording actually
starts, there is a delay of approximately 7 seconds after
q
and
4
on the remote are pressed, or
q
on the recorder is
pressed. To make sure you record the desired scene or
programme in its entirety, first perform the following steps:
1) Press and hold
6
and
q
to engage the RECORD PAUSE
mode.
The recorder then automatically checks the condition
of the tape and, after approximately 7 seconds, re-
enters RECORD PAUSE.
2) Press
4
(
$
) to start recording.
If you want to bypass the B.E.S.T. system and begin
recording immediately, set “B.E.S.T.” to “A.” in step 4
on page 36.
Playback
The recorder assesses the quality of the tape once you initiate
playback. When watching a tape recorded with “B.E.S.T.” set to
“ON”, it is recommended that you leave B.E.S.T. on during
playback as well.
START PLAYBACK
1
Press 4($).
The recorder adjusts the playback picture quality
based on the quality of the tape in use.
B.E.S.T. is active during Auto Tracking. “BEST”
appears blinking on the recorder’s display panel.
NOTES:
When watching a rental tape or one recorded on another
video recorder, or when using this recorder as the player for
editing, set B.E.S.T. to your preference by performing steps 2
through 5 on page 36.
"BEST" only appears at the beginning of automatic tracking.
Even though it doesn't appear after that, the B.E.S.T. function
is operative.
q
12
45
3
6
8
0
7
9
2
4
1
3
HR-J746MS
HR-J449MS