Filter
Top Products
47
NOTES:
●
All necessary cables can be obtained from your dealer.
●
Insert Editing cannot be performed on a VHS/S-VHS cassette
that has had its record safety tab removed, or on a Mini DV
cassette that has had its erase protection switch set to "SAVE".
●
When Insert Editing is performed on a tape that has been
recorded on another video recorder, the inserted portion may
appear distorted.
●
In Insert Editing, the recording speed (SP/LP) is determined by
the previous recording to be replaced. If the previous
recording's speed changes within a single edit, the inserted
picture will be distorted at the switching point. (VHS deck
only)
●
A small portion of the recording which precedes an insert edit
may be erased.
●
Insert Editing is also possible using the rear panel AV1 IN/OUT
or AV2 IN/DECODER connector. When using these connectors,
make sure to select the correct input mode in step 3.
●
Insert Editing is not possible using the DV IN/OUT connector.
RESET THE COUNTER
(VHS DECK ONLY)
5
Press 0000 to change the counter display to "0:00:00".
LOCATE START POINT
6
Determine the edit-in point (the beginning of the
segment to be replaced) using the SHUTTLE ring or the
JOG dial or pressing
@ #
and PAUSE.
● Be sure to engage the Still mode at the edit-in point.
ENGAGE INSERT EDITING
7
Press INSERT.
● Your recorder enters the Insert-Pause mode. (" ", " "
and " " light up on the front display panel.)
● The TV screen changes from the still picture to the
input source you are going to record.
START EDITING
8
Load the source cassette and play back the segment
that is to be inserted. When you reach the start of the
section of the source tape that you wish to insert, press
PLAY to start the tape in your recorder; Insert Editing
begins at this point.
● " " and " " are displayed on the front display panel.
END INSERT EDITING
9
VHS deck
At counter "0:00:00", Insert Editing will stop automati-
cally while the tape continues running in the Play
mode. If you wish to stop Insert Editing before the
specified edit-out point, press 0000.
DV deck
Press STOP to stop the tape in the DV deck.
FOR AV INSERT EDITING (VHS DECK ONLY)
If you want to replace the picture, Hi-Fi audio soundtrack and
normal audio soundtrack all at the same time...
...
In step 7 above, after you press INSERT, press A. DUB also.
(" " and " " blink and " " lights up on the front display
panel.)
PLAY
STOP
PAUSE
A. DUB
1 2 3
4 5 6
7
8 9
0
2
T W
4
1
DV VHS
3
JOG
SHUTTLE
PAUSE
PLAY
STOP
0000
INSERT