47
Additional information
Initial settings
• If you select
On
for
Store Display Mode
,
the system starts up in demonstration mode
for shops, and the initial setup screen appears
every time you turn on the unit after turning
off and on the ignition switch. Select
Off
to
obtain the full performance from the unit.
Basic operations
• In a small scale, the map scrolling may stop
when the map view approaches the border
of the map coverage. Scrolling resumes in a
larger scale when you keep scrolling the map.
Searching for a place
• While driving at a speed greater than
6 mi/h (10 km/h), following operations are
prohibited:
– To enter a destination.
– To operate items in
Setup
Menu except
for the ones in
Guidance Voice
(
Gender
,
Volume
,
Output Channel
,
and
Audio Mixing
).
If you try to do these operations, the following
screen appears, and you cannot continue the
operation.
• The search result is displayed in North Up
view regardless of your map view setting.
• The name you entered to search for a POI
may be different from the name of the search
result.
From the list of POI
• If no POI data exists for the selected city,
POI
not found.
appears on the display. Press
BACK until the city entry menu appears, then
re-enter another city.
POI around a place/route
• If no POI data exists for the selected area,
POI
not found.
appears on the display. Press
BACK until the main categories list appears.
• POI search in
Along Route
is canceled if the
guidance finishes or if rerouting starts before
the search completes.
By coordinates
• If the entered position is out of the database,
Out of the map coverage.
appears on the
display. Enter again.
Basic navigation procedure
• When you reach the area approximately
within 100 ft (30 m) around the destination/
via point, the Navigation System considers
that you have reached your destination/via
point.
How you are guided
• If GPS signal reception is poor, navigation
guidance may not be correct.
• The System may not receive GPS signals in
the following places...
– in a tunnel or parking lot in the building
– under an overhead road
– in a place surrounded by high buildings or
by closely standing trees.
• The position of your car may not be detected
correctly in the following cases...
– when running on a road close to the other
one (e.g. a highway and ordinary road
running in parallel)
– when turning at an almost straight fork in
the road
– when running on a gridiron road
– after taking a ferry, etc.
– when running on a steep mountain road
– when running on a spiral road
– when turning left or right after running
on a long straight road
– when running in a zigzag line on a broad
road
– when starting your car shortly after
starting the engine
– when running for the first time after
installing the unit
– when changing tires or attaching chains
on the tires
Additional information
You cannot operate while
driving. Operate again
after stopping.
KDNX5000_J.indb 47KDNX5000_J.indb 47 23/1/07 7:00:02 pm23/1/07 7:00:02 pm