Filter
Top Products
31
7 PLAYBACK AND SPECIAL-EFFECTS PLAYBACK
7-1 Basic operation
Operation
1. Turn the power ON.
Check the connections and set the [POWER] switch on
the rear panel to ON.
2. Start playback.
Press the [PLAY] button. The [PLAY] indicator on the
display panel lights and playback starts.
3. Stop the playback temporarily.
Press the [STILL] button. The [STILL] indicator on the
display panel lights and the Still mode is engaged.
4. Re-start playback.
Press the [PLAY] button to start playback again.
5. Stop playback.
Press the [STOP] button to stop playback.
Memo:
● When the <REC MODE> switch in <ALARM/SENSOR
MODE> is set to “SENSOR” (“SN-***” is shown on
screen), the following phenomena may occur.
• The playback picture appears to stop for a moment or
sound is interrupted.
● If no signal is input from the selected camera during
recording, the picture may freeze or a black screen
may be displayed.
● Press the [PLAY] button to start playback from the point
where playback was last stopped.
Playback
● Lets you check a recording while recording is taking place.
● Jog/shuttle playback and skip search are available in
addition to normal playback.
● When the [PLAY] button is pressed, playback starts from
the point where playback was last stopped.
Simultaneous Playback mode
Memo:
● The screen may go black or sound may be interrupted
during transitions between events.
Memo:
● When an alarm signal is received, the playback picture
may appear to stop or sound may be interrupted.
However, this does not affect the recording.
POWER
WARNING
SLEEP
REC STOP PLAY STILL
TIMER CANCEL
DISPLAY
MENU
SEARCH
S
E
L
E
C
T
REV FWD
EXECUTE
SKIP/ALARM
SEARCH
REC
CLOCK RESET/ CLEAR
OPE. LOCK
ON
DIGITALVIDEORECORDER VR-510U
[STOP] button [STILL] button
[PLAY] button
Beginning of the hard disk (full)
Event 1
Event 2
Event 3
Event 4
End of the hard disk (0%)
Previous playback
Playback starts
from the position
where the playback
was last stopped.