Filter
Top Products
50
<Recorder Part> Applications
Event Configuration—Manual Event
If a manual event is set (created), any event can be produced
through operation on the Smart Client.
1 Click [+] in [Advanced Configuration]
2 Click [+] in [Events and Output]
3 Double-click [Manual Events]
The [Manual Event Properties] window appears.
4 Select the event setting target
● For setting all cameras: select [Global]
● For setting each camera individually: select the camera
name to set
5 Click [Add]
The event name setting screen appears.
6 Enter the event name and click [OK]
Note:
● If you change the camera name after setting the manual
events, manual events already registered may not work. In
this case, delete the manual events, then register them
again.
● When you specify the event, specify the action for the
event. (A Page 52 to 56).
● When you select the setting to receive an e-mail when the
event you specified occurs, perform mail setup (A Page
60 "Mail Setup for Management Application") and activate
the setting to receive an e-mail upon the occurrence of an
event. (A Page 62 "Receive an e-mail upon the
occurrence of an event")
Events and Actions
(continued)