Filter
Top Products
Getting started
Getting started
8
XV-NA7SL/LET0212-004A/English
How to set the unit to supply RGB signals
The unit cannot output the RGB signals from the SCART connector and the S-video (Y/C) signals from the S-VIDEO jack
simultaneously.
¶ When the unit is turned off
1 Set the VIDEO SIGNAL SELECTOR to "COMP./RGB."
Note that you must change the switch position while the unit power is off. Otherwise, the changed setting is not
effective.
2 Turn the unit to on.
The RGB signal outputs from the SCART connector.
Connection to a TV equipped with component jacks
You can enjoy high picture quality by connecting the unit’s COMPONENT VIDEO OUT jacks to the COMPONENT VIDEO
IN jacks of your TV with the video cables.
• Connect "Y" to "Y," "P
B" to "PB"(CB), "PR" to "PR"(CR) correctly.
NOTES
• If you connect to a TV with the VIDEO OUT (VIDEO or S-VIDEO) jack, or the SCART connector, make sure that the NTSC/
REMOTE/PAL switch set to "PAL."
• You must change the switch position on the rear panel while unit power is off. Otherwise, the changed setting is not effective.
NOTES
• You must change the switch position on the rear panel while unit power is off. Otherwise, the changed setting is not effective.
• In this connection, make sure that the NTSC/REMOTE/PAL switch set to "NTSC" or "REMOTE."
• When the component video input jacks on the TV is of the BNC type, use an adapter to convert a pin jack to a BNC jack
(optional).
• Set [ANALOG OUT] in the [AUDIO] preference display to [2-CH STEREO] (see page 60).
• If your TV has a monaural audio input instead of stereo, you need to use an optional audio cable which converts stereo audio
output to monaural.
• To improve audio sound quality, connect the AUDIO OUT jacks to your separate audio equipment (see the following pages).
AV COMPU LINK
PCM / STREAM
COAXIAL
SUBWOOFER
CENTER
LEFT
RIGHT
REAR FRONT
OPTICAL
VIDEO
S-VIDEO
DIGITAL OUTAUDIO OUT
COMPONENT
YP
B PR
VIDEO OUT
VIDEO SIGNAL SELECTOR
Y/C REMOTE
NTSC PAL
VIDEO
/S-VIDEO
/AV OUT
PAL COMPONENT
COMP.
/RGB
YP
B
P
R
COMPONENT IN
VIDEO
AUDIO
RIGHT
LEFT
S-VIDEO
IN
The unit
In this connection, set the NTSC/
REMOTE/PAL switch to "NTSC" or
"REMOTE."
TV
Component video cable (not supplied)
Audio cable (supplied)
WhiteRed
White
Red
RedGreen
Blue
RedGreen
Blue
XV-NA7SL(B).book Page 8 Wednesday, July 31, 2002 1:00 PM