Filter
Top Products
Getting started
Getting started
12
XV-NA7SL/LET0212-004A/English
You can enhance the playback sound quality by connecting either of the unit’s DIGITAL OUT jacks to the digital input of
an amplifier, etc. by using an optical or a coaxial digital cable (optional). The digital audio signal from a disc will be
transferred directly. If you connect the unit to a Dolby Digital or DTS decoder or an amplifier with a built-in decoder using
an optional digital cable, you can enjoy high-quality surround sound.
For a digital connection, connect the unit’s DIGITAL OUT (OPTICAL or COAXIAL) to the digital input of a digital audio
device using an optical or a coaxial digital cable.
Note that the DIGITAL OUT jacks on the unit have been designed and equipped exclusively for enjoying the digital
surround sound playback through the unit. It is not recommended to use the jacks for digital dubbing. When recording
the sounds (DVD AUDIO, DVD VIDEO, SVCD, Video CD or Audio CD) played back on the unit, record them through the
analog jacks (in this case, set [ANALOG OUT] in the [AUDIO] preference display to [2-CH STEREO]) (see page 60).
When all the audio/video connections have been made, insert the AC power plug to the wall outlet. Make sure that plugs
are inserted firmly. The STANDBY/ON button lights in red.
Warning
• Disconnect the power cord if you are not going to use the unit for a long time.
• Disconnect the power cord before cleaning the unit.
• Disconnect the power cord before moving the unit.
• Do not connect or disconnect the power cord with wet hands.
• Do not pull the power cord when disconnecting it, as this may damage the cord and cause fire, electric shock, or other
accidents.
Caution
• Do not alter, twist or pull the power cord, or put anything heavy on it, which may cause fire, electric shock, or other
accidents.
• If the cord is damaged, consult a dealer and have the power cord replaced with a new one.
To connect to a digital audio device
NOTES
• When you make digital connection, we recommend also to make the analog connection, because, depending on discs, no
signal may be output from the DIGITAL OUT.
• When you connect the unit’s DIGITAL OUT to a digital audio device, before using, set [DIGITAL AUDIO OUTPUT] in the [AUDIO]
preferences correctly according to the connected audio device. If [DIGITAL AUDIO OUTPUT] is not set correctly, loud noise may
be generated from speakers, causing damage to them. See [DIGITAL AUDIO OUTPUT] on page 60.
• When you connect the unit’s DIGITAL OUT to a Dolby Digital or DTS decoder (or amplifier with a built-in decoder) to enjoy
surround sound, the unit’s [D. RANGE COMPRESSION] setting in the [AUDIO] preferences is invalid. Make appropriate
surround audio settings on the decoder.
To connect the power cord
AV COMPU LINK
AV OUT
PCM / STREAM
COAXIAL
SUBWOOFER
CENTER
LEFT
RIGHT
REAR FRONT
OPTICAL
VIDEO
S-VIDEO
DIGITAL OUTAUDIO OUT
COMPONENT
YP
B PR
VIDEO OUT
VIDEO SIGNAL SELECTOR
Y/C REMOTE
NTSC PAL
VIDEO
/S-VIDEO
/AV OUT
PAL COMPONENT
COMP.
/RGB
AUDIO
RIGHT
LEFT
IN
OPTICAL
COAXIAL
DIGITAL
IN
The unit
When using the DIGITAL OUT (OPTICAL) jack, remove the protection cap. Do not lose
the removed cap.
When the DIGITAL OUT (OPTICAL) jack is not used, replace the protection cap in the
jack.
RedWhite
White
Red
Digital equipment
Audio cable (supplied)
Optical digital cable (not supplied)
Coaxial digital cable (not supplied)
XV-NA7SL(B).book Page 12 Wednesday, July 31, 2002 1:00 PM