Filter
Top Products
Programming TV programmes
17
Programmieren von TV-Programmen
The satellite receiver has already been factory pre-programmed for satellite re-
ceiving systems with feed systems (receiving system) which have an oscillator fre-
quency of 9.75 GHz. All of the programmes set up are listed in the table enclosed.
If your satellite receiving system uses a feed system with a different oscillator fre-
quency, the receiver only needs to be matched to the feed system oscillator fre-
quency during the installation.
The procedure for this can be found in section: “Initial settings, Oscillator fre-
quency“.
Note on programme memory locations
The receiver has a 250 channel memory that can be assigned with TV or radio
programmes in any given manner.
The receiver has been factory pre-programmed according to the programme table
with:
150 TV programmes and
100 radio programmes.
Programme memory is organised here so that the TV programmes are located in
programme slots from 1 upwards while the radio programmes are located in pro-
grammes slots from 250 downwards. See also the following display:
Since only one sound programme (TV accompanying sound or a radio programme)
can be stored in a programme memory, with the factory presetting:
in “TV mode“
on reception of TV programmes in programme slots 151 to 250 the original TV
sound is not sent but instead the programmed radio sound
in “radio mode“
on reception of radio programmes from programme slots 101 to 250 the sound of
the corresponding TV programme is sent.
The assignment of the programme slots can be changed as desired.
Tuning in TV programmes
To tune in to new TV programmes, the video and audio reception parameters need
to be set up accordingly.
The latest programme assignments can be obtained from satellite programme
magazines, or called up via the videotext of programme Sat 1 from page 675.
•
Select the programme slot that you want to change.
•
Call up the video menu by pressing the
+ keys in succession.
or