Filter
Top Products
Connecting up and putting into operation
7
Anschluß und Inbetriebnahme
The following section is intended specifically for the specialist dealer. If you are not
carrying out the installation yourself, there is no need to pay any attention to this
section. Sample configurations are to be found in section: “Connection examples“..
Attention
Do not connect the unit to the mains until after the installation work has been car-
ried out properly.
Please note the guidance given in section: “Safety- and Installation Instructions“
Connecting up the unit
Satellite signal connection
•
Connect up the receiver‘s Sat IF input (5) to the satellite receiving system.
For the connection use a coaxial cable with an F-type connecting plug.
If the F connector is not yet fitted to the cable,
•
Insulate the cable as indicated in the following illustration, and
•
Carefully screw the F connector onto the cable end until it is firmly seated on
the cable.
Attention
When fitting the plug, make certain that none of the fine wires of the braided shield
makes contact with the inner conductor giving rise to a short-circuit.
Receiving system presets
Presetting carried out for the control signals was for conventional receiving sys-
tems, thus 14/18 V for polarity switching and 22 kHz switching signal for satellite
selection in the case of multifeed receiving systems.
If DiSEqC or tone-burst switching matrices are to be used in the receiving system,
the default setting must be changed in the initial setup menu at menu entry
“DiSEqC“.
For this, refer to section: “Initial settings, DiSEqC menu“.
Also comply with the technical guide for the matrices.
TV and video recorder connection (VCR)
•
Connect up the satellite receiver (TV Scart socket) and TV set with a Scart ca-
ble.
If your TV set has stereo capability, a Scart connection allows you to receive the
sound in stereo.
•
Connect-up the video recorder and satellite receiver (VCR Scart socket) again
using a Scart cable.