Filter
Top Products
Initial settings
23
Grundeinstellungen
In the initial setup menu, matching of the satellite receiver to the satellite receiving
system is carried out.
Important
The receiver has already been factory pre-programmed for standard satellite re-
ceiving systems.
Alterations to the initial setting are therefore necessary only if your receiving sys-
tem deviates from this type of installation or if you happen to want different set-
tings.
The settings in the initial setup menu are generally carried out by the specialist
dealer on installation of the satellite receiving system.
To prevent any unintentional alterations in the initial settings, the initial setup menu
can be invoked only from the switched-off state.
Calling the initial setup menu
•
Switch the unit into standby.
•
Press both the programme selection buttons (2)
on the receiver si-
multaneously and keep them pressed.
•
Switch the unit on via the key on the remote control.
•
Release the
buttons when “C 38“ appears on the LED display.
C 38 is the factory preset UHF output channel. If the UHF channel has already
been altered, the appropriate channel selection appears
(between Ch. 21 and Ch. 69).
The initial setup menu is displayed.
Setting option:
Modulator: channel 21 to 69
OSD language: bilingual German / English
LNB supply voltage: Off / On
LNB power supply in standby: Off / On
Programme selection: 1-/ 2-/ 3-digit / free entry
OSD: Off / On (can be set individually
for TV and radio)
Type of remote control: 26 or 24 keys.
Oscillator menu: LO 1 to LO 4
DiSEqC menu:
See separate menu in section “DiSEqC"
The bottom line shows the keys you can use to make the settings.
Settings are made in the initial setup menu in the same manner as in the other
menus for the station programming:
•
Select menu entries with the
keys.
•
Carry out settings and call up submenus with the keys
(and use numeric keys
.. on inputting frequency).
•
Press the
key twice to save your settings.
•
Return with the
key.
Modulator-output channel
The modulator‘s UHF output channel can be entered in the range from channel 21
to 69.
Default: channel “38“