Filter
Top Products
Initial settings
24
When making the setting, it should be ensured that there is at least one blank
channel above and below the output channel in order to avoid interference.
OSD language-
Here you can select the language for the on-screen displays. The choice available
comprises: German and English.
Default:
German
LNB supply voltage
Here you can turn off the power supply for the feed system if this is implemented
by an external power supply and signal selection is likewise not carried out by
means of the LNB supply voltage (e.g. Kathrein single-cable feed system UAS
330).
Note
If there are switchover matrices in the receiving system, the LNB supply voltage
needs to be turned in all cases..
Default:
ON
LNB supply voltage in standby
When the receiver is in standby the LNB supply voltage is normally switched off.
If terrestrial signals and satellite signals are combined in the receiving system, and
the power supply for the relevant components comes from the receiver, the power
supply must also be guaranteed when the receiver is in standby.
In this case switch the power supply in standby to “
On
“.
Default: “
Off
“.
Programme selection
You have the option of entering the programme number in one-, two-, or three-digit
form or in “free” form
Default: “
free
“.
Setting Settable programme slots
One-digit input Programme slots 1 to 9
Two-digit input Programme slots 1 to 99
Three-digit input Programme slots 1 to 250
Free input Programme slots 1 to 250
Note
If a recording is pre-programmed in the timer for a programme slot ≥100, the timer
must be cleared first in order that a change in the programme slot entry can be car-
ried out.
On Screen Displays (OSD)
Here you can select whether the programme slot and programme name are to be
displayed continuously, or whether they are to be removed again approximately
three seconds after programme changeover..
This setting can be made differently in TV mode and radio mode.
Default: TV mode
“
Off
“.
Radio mode
“
On
“.
To call the initial setup menu for radio, the receiver must be switched into radio
mode before being switched off. Then call the initial setup menu in the usual way.